Properties of BC 1786 A/B

Product Identification 2 part epoxy
Color, Part A: Black
Color, Part B: White
Color Mixed: Gray
Shelf Life 25C, Part A: 12 months
Shelf Life 25C, Part B: 12 months
Flammability, 94 V-O: Designed to pass

Viscosity

Viscosity @ 25C, Mixed: 1,500 - 3,000 cps
Viscosity @ 25C, Part A: 2,500 - 3,500 cps
Viscosity @ 25C, Part B: 1,200 - 1,600 cps

Weight per Gallon

Weight/Gallon A: 11.40 - 11.50 lb/gal Weight/Gallon Mixed: 11.00 - 11.20 lb/gal
Weight/Gallon B: 10.70 - 10.90 lb/gal

Mix Ratio by Weight: 100:95 Mix Ratio by Volume: 1:1
Cure Schedule, Days: 7 days @ 25°C Alternate Cure, Hours: 3-4 hours @ 25°C:
Filler Stability, Part A: Good Pot Life @ 25°C: 60 min, 200 gram

Cured Properties

Coeff Therm Exp: 111 - 121 (EXP-6)in/in C Hardness, Shore D: 68 - 76

General storage and safety considerations for BC 1786 A/B

Storage: Store in original containers at room temperature and off the floor. Prevent exposure to cold or elevated temperature.

Handling:  Wear suitable protective clothing to prevent skin and eye contact. Prevent contact with vapors by providing adequate ventilation or personal NIOSH approved respirators. Isolate from epoxy resin and work areas to limit exposure to other personnel, tools or equipment.

Spills, disposal:  Only properly trained and equipped personnel should be involved with clean up or spills. Small spills can be cleaned up with absorbent rags or sand. Dispose or any wastes or empty containers in accordance of all applicable federal, state and local regulations.

Please read the MSDS for complete information regarding the handling of this product .For further information contact the BCI technical sales department at (847) 488-0123.

Warranty: All Recommendations, estimates and technical data contained herein are based on tests we believe to be reliable and correct. Bonding Concepts Inc warrants its product to be free of manufacturing defects and that at the time and place of shipment, our material will meet current published physical properties when applied with BCI directions in accordance with BCI standards. Bonding Concepts Inc liability is limited to replacement of material found to be defective. As BCI has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and / or our information is valid in a particular circumstance. Responsibility remains with the buyer to the design application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to manage any existing patents.